Serving Gulfport, Harrison County and the western Mississippi coastCall (228) 678-7783

Harrison County & the west coast

Spray Foam Insulation in Gulfport, MS

Open-cell and closed-cell foam for attics, walls, crawl spaces and metal buildings, priced in writing after we see the house.

  • Free estimates after we look at the house
  • Quotes list foam type, thickness and R-value for each area
  • Roof leaks, damp wood and termite access checked before we spray

Insulation Built for Gulf Coast Heat and Humidity

Spray foam insulation in Gulfport has one main job: keep summer out of the house. Gulfport's 1991-2020 normals at the airport show August afternoons averaging 90.7F, July nights that only fall to about 74.9F, and around 63 inches of rain a year. Air that warm and that wet finds every gap in a ceiling, every leaky duct joint and every opening under a raised floor. We seal and insulate those spots with open-cell foam, closed-cell foam, blown-in fill or a mix, depending on what each part of the house needs.

Where the heat gets in

In most Gulfport houses the air handler and the ductwork live in the attic. On a July afternoon that attic is far hotter than the yard, so cooled air leaking from a duct seam or heat soaking through a thin layer of old batts goes straight onto your power bill. There are two common fixes. One is to seal the ceiling and blow in insulation to full depth. The other is to spray foam on the underside of the roof deck so the attic, the ducts and the air handler all end up inside the conditioned part of the house. We look at the roof, the duct layout and your budget before recommending either.

Closed cell vs open cell

Open-cell foam is soft and spongy, runs roughly R-3.5 to R-3.7 per inch according to HomeGuide, and costs less per square foot. It is a common choice under roof decks in hot, humid climates. Closed-cell foam is dense and rigid, around R-5 to R-7 per inch, and slows water vapor. It is the better pick for the underside of raised floors, crawl space walls, metal buildings and anywhere moisture is a worry. Plenty of houses get both: open cell overhead, closed cell below.

Spray foam insulation cost

HomeGuide's 2026 cost guide puts installed spray foam at $1.50 to $5.00 per square foot, with open cell at $1.50 to $3.50 and closed cell at $3.00 to $5.00. Fixr lists $3.15 to $7.50 per square foot for existing walls and $2.75 to $6.50 for new construction. Foam on a roof deck runs $1,500 to $9,000 in HomeGuide's attic figures. Those are national ranges. Your price depends on square footage, thickness, access and prep, and the number on our written quote is the number you pay.

Rebate worth checking

Mississippi Power's residential ceiling insulation rebate form lists 20 cents per square foot of insulation added in single-family homes, as long as the finished attic reaches R-38 (about 13 inches). Spray foam, cellulose and fiberglass are all listed as eligible materials. Paperwork is due within 90 days of the invoice, funding is limited and first-come, first-served, and the utility may inspect. If your power comes from Mississippi Power, ask us to write the quote so the R-value and square footage are easy to submit.

Code, climate zone and termites

Harrison, Hancock and Stone counties sit in IECC Climate Zone 2A, the hot-humid zone. Mississippi's statewide residential energy code is voluntary, but Gulfport is among the cities that adopted their own. ENERGY STAR suggests R-49 for an uninsulated Zone 2 attic, or adding about R-38 where 3 to 4 inches already exist. Mississippi State University Extension reports Formosan subterranean termites established in Harrison and Hancock counties and warns that foam can hide leaks and infestations, so we plan termite inspection access before foaming near sills and foundations.

Picking an insulation contractor

If you are comparing spray foam insulation contractors, insulation companies or whoever came up for spray foam insulation near me, ask each one the same questions. Which foam goes where, and how thick? What R-value will each area end up at? What happens to the ducts and the attic hatch? How do you handle termite inspection access? How long should we stay out of the house after spraying? A good quote answers all of that on paper. Ours does. Get a free estimate

Why Homeowners Call Spray Foam Insulation Gulfport

We start in the attic and under the house

Heat and humidity hit coastal homes from both directions. We check the roof deck, the ducts, the air handler and the crawl space or raised floor before writing anything down.

Every area priced on its own line

Material, thickness, R-value and price for the attic, walls, floor or shop, so you can do the most important area now and the rest later.

We know the rebate paperwork

Mississippi Power's ceiling insulation rebate needs R-38 and the square footage added. We put both on the quote and invoice.

Foam where foam makes sense

Spray foam is not always the cheapest way to hit a target. When sealing plus blown-in fill gets you there for less, we say so and price it.

Spray Foam Insulation in Gulfport, MS

Common Questions

How much does spray foam insulation cost in Gulfport?

National guides put installed spray foam at $1.50 to $5.00 per square foot (HomeGuide, 2026), with open cell at the low end and closed cell at the high end. A 1,000 square foot area runs about $1,500 to $5,000 in HomeGuide's figures. We measure the space and give you a written price; that written figure is what you pay.

What is the cost difference between spray foam and fiberglass?

Fiberglass costs less up front. Fixr lists blown fiberglass at $1.65 to $2.60 per square foot, while HomeGuide lists open-cell foam at $1.50 to $3.50 and closed cell at $3.00 to $5.00. Foam also air seals as it insulates, which fiberglass does not, so the comparison depends on how leaky the house is and where the insulation goes.

Can mold grow behind spray foam insulation?

Foam itself is not food for mold, but it can trap water that gets in from a roof leak, a plumbing leak or a wet crawl space. That is why we fix or flag leaks first and use closed-cell foam where moisture is likely. Once it is sprayed, a slow leak can be harder to spot, so keeping an eye on the roof matters.

Does it snow in Gulfport?

Rarely. Gulfport's climate is humid subtropical and moderated by the Gulf; flurries are uncommon and most years see no real accumulation. The record low is 1F from February 1899, but insulation here is mostly about summer heat and humidity, not snow load.

Is there a DIY spray foam kit I can use instead?

Two-part kits are sold for small areas like a rim board or a few gaps. For an attic, a roof deck or a whole floor, getting even thickness and proper mixing is hard without professional equipment, and poorly mixed foam can smell, shrink or pull away from framing. We are happy to tell you which small jobs are reasonable to do yourself.

Should I spray the roof deck or insulate the attic floor?

If your air handler and ducts are in the attic, foam on the roof deck brings them inside the conditioned space, which can help a lot in this climate. If the ducts are elsewhere and the roof needs work soon, sealing the ceiling and blowing in fill to R-38 or more often costs less. We price both when both make sense.

How long do I need to stay out after spray foam?

HomeGuide advises staying out for at least 24 hours after spray foam is applied so the foam can cure and the area can air out. We give you a specific time for your job and ventilate during and after the work.

Gulfport and the Western Coast

We work from Gulfport outward: Long Beach and Pass Christian along the beach, DeLisle and Diamondhead around the Bay of St. Louis, Bay St. Louis, Waveland and Pearlington in Hancock County, Kiln up the Jourdan River, and Lyman, Saucier and Wiggins north along Highway 49. The work changes as you go. Beachfront towns rebuilt after Katrina have many raised homes with exposed floors. Older neighborhoods have attics with decades-old insulation. Inland communities like Lyman and Saucier have more slab ranch houses, acreage and metal shops. Each town page below lists what we found out about that place and what it means for insulation.

Attic & Roof Deck Insulation in Gulfport, MS

What We Insulate

Six services, each matched to how coastal houses and buildings actually lose cool air.

Spray Foam Insulation

Open-cell or closed-cell foam that insulates and air seals in one pass, for roof decks, walls, floors and metal.

Learn more →

Attic & Roof Deck Insulation

Seal the ceiling and blow it full, or foam the roof deck so the ducts stay cool: we price whichever fits your attic.

Learn more →

Crawl Space Encapsulation

Seal the space under the house, or foam the floor of a raised home, to stop damp air and floor drafts.

Learn more →

Wall Insulation

Foam or dense-pack fill in exterior walls for rebuilds, additions and older homes with empty cavities.

Learn more →

Metal Building & Shop Insulation

Closed-cell foam that keeps steel shops, barns and garages cooler and stops condensation dripping.

Learn more →

Insulation Removal

Wet, moldy, rodent-soiled or storm-damaged insulation vacuumed out so the attic can be sealed and redone.

Learn more →

Get a Spray Foam Insulation Estimate

Tell us about the hot room, the damp floor or the dripping shop. We will look and put a price in writing.

Call Now: (228) 678-7783